2016-09-15 - Re: [GRASE-Hotspot] Ip address configuration

Header Data

From: Rishabbh A Dua <du***h@gmail.com>
Message Hash: d7dd55317c686992f7a78a36556493244c21e66415a1fded4bf9bbcdd7ca8a24
Message ID: <37257a25-ff07-481d-a341-7bf5cc2cb817@grasehotspot.org>
Reply To: <CAESLx0J85rUwTimc02USuW–Ru-e_ogjODydUvoaVh_au_XU6g@mail.gmail.com>
UTC Datetime: 2016-09-15 04:19:51 UTC
Raw Date: Thu, 15 Sep 2016 04:19:51 -0700

Raw message 

ok i will assign static ip address on wan (internet) interface and will 
disable dhcpcd and will get back with the results.

Regards

Rishabbh

On Thursday, 15 September 2016 16:46:48 UTC+5:30, timwhite88 wrote:
>
> You'll need to make sure that dhcpcd is doing nothing on that interface. 
> It's possible it's doing IPv6 for the clients, which will confuse them.
>
> Tim
>
> On Thu, Sep 15, 2016 at 9:04 PM, Rishabbh A Dua <du***.@gmail.com 
> <javascript:>> wrote:
>
>> Hi Tim, Emre
>>
>> My perception was since dhcpcd is running on eth1 ( usb ethernet port 
>> which is connected to access point), it was getting ipv4ll address.
>> So in order to disable ipv4ll address on this interface, i modified 
>> /etc/dhcpcd.conf file and added noipv4ll at the end of file and it worked 
>> (ie no ipv4ll address on eth1 in case dhcp server is not found). 
>>
>> However, when i connect some device with access point, it is still stuck 
>> at obtaining IP address.
>>
>> Any thoughts/ pointers on this?
>>
>> Thanks
>> Rishabbh
>>
>>
>> On Thursday, 15 September 2016 12:50:01 UTC+5:30, timwhite88 wrote:
>>>
>>> Please collect support information as described at 
>>> https://grasehotspot.org/support/collecting-support-information/
>>>
>>> It's hard to know what your setup is from that information, what is WAN 
>>> and LAN. You also don't appear to have a network interface set to manual 
>>> (see https://grasehotspot.org/documentation/hardware-setup/) for Coova 
>>> Chilli to use.
>>>
>>> Regards
>>>
>>> Tim
>>>
>>>
>>> On Thu, Sep 15, 2016 at 3:55 PM, Rachitta A Dua <ra***.@gmail.com> 
>>> wrote:
>>>
>>>> Hi
>>>>
>>>> I have installed grase on a Raspberry Pi. The moment I installed it, it 
>>>> worked fine. Even worked properly after an immediate reboot. However, when 
>>>> I started the device the following day, it wasn't working. The issue is 
>>>> that I cannot connect to the access point. If i try to connect my mobile to 
>>>> the access point, it just shows connecting but never connects.
>>>>
>>>>
>>>> This is the result of ifconfig
>>>>
>>>> eth0      Link encap:Ethernet  HWaddr b8:27:eb:38:08:33
>>>>           inet addr:192.168.1.8  Bcast:192.168.1.255  Mask:255.255.255.0
>>>>           inet6 addr: fe80::a362:20f7:2ad9:ced1/64 Scope:Link
>>>>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>>>>           RX packets:917 errors:0 dropped:0 overruns:0 frame:0
>>>>           TX packets:519 errors:0 dropped:0 overruns:0 carrier:0
>>>>           collisions:0 txqueuelen:1000
>>>>           RX bytes:82599 (80.6 KiB)  TX bytes:86937 (84.8 KiB)
>>>>
>>>> eth1      Link encap:Ethernet  HWaddr 00:e0:4c:53:44:58
>>>>           inet addr:169.254.161.241  Bcast:169.254.255.255 
>>>>  Mask:255.255.0.0
>>>>           inet6 addr: fe80::26a5:b629:f948:92c3/64 Scope:Link
>>>>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>>>>           RX packets:11 errors:2 dropped:1 overruns:0 frame:0
>>>>           TX packets:78 errors:0 dropped:0 overruns:0 carrier:0
>>>>           collisions:0 txqueuelen:1000
>>>>           RX bytes:3350 (3.2 KiB)  TX bytes:16024 (15.6 KiB)
>>>> lo        Link encap:Local Loopback
>>>>           inet addr:127.0.0.1  Mask:255.0.0.0
>>>>           inet6 addr: ::1/128 Scope:Host
>>>>           UP LOOPBACK RUNNING  MTU:65536  Metric:1
>>>>           RX packets:196 errors:0 dropped:0 overruns:0 frame:0
>>>>           TX packets:196 errors:0 dropped:0 overruns:0 carrier:0
>>>>           collisions:0 txqueuelen:1
>>>>           RX bytes:25419 (24.8 KiB)  TX bytes:25419 (24.8 KiB)
>>>>
>>>> tun0      Link encap:UNSPEC  HWaddr 
>>>> 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
>>>> -00
>>>>           inet addr:10.1.0.1  P-t-P:10.1.0.1  Mask:255.255.255.0
>>>>           UP POINTOPOINT RUNNING  MTU:1500  Metric:1
>>>>           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>>>>           TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>>>>           collisions:0 txqueuelen:100
>>>>           RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)
>>>>
>>>> wlan0     Link encap:Ethernet  HWaddr b8:27:eb:6d:5d:66
>>>>           UP BROADCAST PROMISC  MTU:1500  Metric:1
>>>>           RX packets:1 errors:0 dropped:1 overruns:0 frame:0
>>>>           TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>>>>           collisions:0 txqueuelen:1000
>>>>           RX bytes:60 (60.0 B)  TX bytes:0 (0.0 B)
>>>>
>>>> I believe it's the ip address of eth1 that is creating the issue. 
>>>> Please help me out.
>>>>
>>>> -- 
>>>> This mailing list is for the Grase Hotspot Project 
>>>> http://grasehotspot.org
>>>> --- 
>>>> You received this message because you are subscribed to the Google 
>>>> Groups "Grase Hotspot" group.
>>>> To unsubscribe from this group and stop receiving emails from it, send 
>>>> an email to gr***.@grasehotspot.org.
>>>> To post to this group, send email to gr***.@grasehotspot.org.
>>>> Visit this group at 
>>>> https://groups.google.com/a/grasehotspot.org/group/grase-hotspot/.
>>>> To view this discussion on the web visit 
>>>> https://groups.google.com/a/grasehotspot.org/d/msgid/grase-hotspot/8070344e-1d8d-4120-a790-77a10651dd64%40grasehotspot.org 
>>>> <https://groups.google.com/a/grasehotspot.org/d/msgid/grase-hotspot/8070344e-1d8d-4120-a790-77a10651dd64%40grasehotspot.org?utm_medium=email&utm_source=footer>
>>>> .
>>>>
>>>
>>> -- 
>> This mailing list is for the Grase Hotspot Project 
>> http://grasehotspot.org
>> --- 
>> You received this message because you are subscribed to the Google Groups 
>> "Grase Hotspot" group.
>> To unsubscribe from this group and stop receiving emails from it, send an 
>> email to gr***.@grasehotspot.org <javascript:>.
>> To post to this group, send email to gr***.@grasehotspot.org 
>> <javascript:>.
>> Visit this group at 
>> https://groups.google.com/a/grasehotspot.org/group/grase-hotspot/.
>> To view this discussion on the web visit 
>> https://groups.google.com/a/grasehotspot.org/d/msgid/grase-hotspot/a39b6967-7450-4ae5-8fd7-44e72d7c7c2c%40grasehotspot.org 
>> <https://groups.google.com/a/grasehotspot.org/d/msgid/grase-hotspot/a39b6967-7450-4ae5-8fd7-44e72d7c7c2c%40grasehotspot.org?utm_medium=email&utm_source=footer>
>> .
>>
>
>

Thread